OPERATION NOTE: This added page shows the differences for machines equipped with Single Lever Transmission/Steering Control. 2 TRANSMISSION/STEERING LEVER The transmission/steering lever (3) is used to select direction, range gear, and high or low steering clutches. Center position of the transmission/steering lever (3) is neutral. Move the safety lock lever to the UNLOCK position. This action sup- plies oil to the transmission/steering lever control valve making it oper- ational. 2 Forward and Reverse Motion Push the transmission/steering lever forward to engage the forward clutch for forward motion.
Pull the transmission/steering lever backward to engage the reverse clutch for reverse motion. Remark There is a hydraulically actuated detent for both forward and reverse, which is functional only when the engine is running and the safety lock lever is in the UNLOCK position. Remark When the transmission/steering lever is operated in reverse position, the backup alarm will automatically sound. 2 Range Gear Selection Rotate the transmission/steering lever to engage the desired transmis- sion range clutch. Three (3) rotary positions of the transmission/steering lever select the range clutch as follows:
Counterclockwise position is 1st gear; center position is 2nd gear; and clockwise position is 3rd gear. Remark There is a mechanical detent for each of three (3) rotary posi- tion of the transmission/steering lever. The three (3) trans- mission ranges and the two (2) steering drive ranges (described below) give a total of six (6) operating ranges in which the machine can operate. 2 Pivot Turns and Modulated Turns Move the transmission/steering lever to the left to make a left turn and to the right to make a right turn. When the transmission/steering lever is moved all the way to the left or the right, the steering clutch on that side is released and the brake on that side is applied.
This results in a pivot turn. Moving the transmission/steering lever partially to one side gives par- tial pressure to the clutch and brake. This results in a modulated turn. Remark The transmission/steering lever is spring loaded to the center for straight motion. D87E-2 D87P-2 2-25