Komatsu — COLD WEATHER STARTING

OPERATION 4. Carry out preheating. There are the following two ways of carrying out preheating. First use the convenient automatic preheating system. Automatic Preheating Turn grid heater timer switch (4) to the AUTO position. When the switch is turned to the AUTO position, preheating is automatically car- ried out according to the ambient temperature. The light above the switch illuminates during the preheating operation. When preheating is completed, the lamp above the switch will go out. 5. When the preheating is completed, turn the start switch key to the START position to start the engine and release the key the instant the engine starts.

The key will automatically return to the ON posi- tion. Remark To prevent damage to the starter motor and avoid low battery output, do not continuously crank the engine for more than 30 second intervals. Allow at least a two minute recovery pe- riod between cranking. 6. After starting the engine, return grid heater timer switch to the OFF position. Remark If the engine can not start after automatic preheating, start it using manual preheating. Manual Preheating Turn grid heater timer switch to position I or II . The light above the switch illuminates during the preheating operation. When preheating is completed, the switch will then return automatically to the following position.

From position I it will return to AUTO From position II it will return to OFF The preheating times are as shown below. If the preheating time is too long or too short, the engine will not start easily. Observe the correct preheating time. 2-46 D87E-2 D87P-2 Ambient temperature Preheat time 0 to -5°C (32 to 23°F) --- -5 to -10°C (23 to 14°F) 15 seconds -10 to -20°C (14 to -4°F) 30 seconds -20 to -30°C (-4 to -22°F) 45 seconds