mercedes-benz Unimog Model Series 405 — UGE_Euro6_en.pdf

Exhaust aftertreatment Drive Euro 6 technology and vehicle packaging In order to meet the requirements of the Euro VI legislation and customer demands for minimal fuel consumption, new engines and a new exhaust aftertreatment system were developed. The engines feature Common Rail injection and exhaust gas recirculation and are designed for minimal con- sumption. The new exhaust aftertreatment system removes particulates and nitrogen oxides. Function description: • The exhaust first flows through the oxidation catalytic converter. This converts the hydrocarbons and carbon monoxide present into carbon dioxide and water.

Further- more, part of the nitric oxide (NO) is oxidized to nitrogen dioxide (NO2). • The particles are separated through adhesion and collec- ted in the porous filter structure of the diesel particulate filter (DPF). In the particulate filter, the NO2 reacts with the stored soot to produce NO und CO2. The deposits are broken down and the system regenerates itself: "pas- sive regeneration". In order to achieve complete filter regeneration, the "passive regeneration" is coupled with "active regeneration". In the case of active regeneration, a reaction takes place between O2 and soot at tempe- ratures above the passive regeneration range.

In order to reach the temperatures required for this, the exhaust temperatures are increased by injecting HC in the form of diesel fuel. The HC reacts exothermically in the oxidation catalytic converter and increases the temperature of the exhaust. • SCR catalytic converter: The BlueTec diesel technology reduces the proportion of nitrogen oxide in the exhaust through the addition of AdBlue® (aqueous urea solution). The aqueous AdBlue® solution is injected into the hot exhaust via a metering valve. The exhaust aftertreatment system consists mainly of:

• Oxidation catalytic converter (DOC) • Diesel particulate filter (DPF) • SCR catalytic converter • Slip catalytic converter The system also includes the AdBlue® metering unit with va- rious sensors, the ACM electronic unit (Aftertreatment Con- trol Module) and the fuel (HC) metering system. Low-sulfur fuel is required. The fuel may contain up to 7% biodiesel. 23 Introduction of the New Unimog Generation | Model Series 405 – This printout will not be recorded by the update service. Status: 03 / 2013 –