Chassis Mechanical sliding caliper disk brake The mechanical sliding caliper disk brake is a pneumatic single-piston brake. It has been designed for use on the front axle (model designation 737.572) and rear axle (model desi- gnation 747.572) as a service, auxiliary and parking brake. It is mechanically operated via a diaphragm or spring-loaded cylinder. This is directly attached to the brake caliper. The brake caliper slides axially on the guide pins of the brake carrier. The brake pads are held and supported in the brake carrier so that they can move axially. The brake pads are held in place by a retaining bracket and by holddown springs.
In order to correct for brake wear, the operating mechanism of the brake is equipped with an automatic adjusting mecha- nism. This maintains a constant specified air gap irrespective of the load spectrum and different operating conditions. Together with the sturdy and rigid construction of the brake caliper, this allows the operating travel of the brakes to be controlled reliably and increases the reserve travel for emer- gency braking. The direct connection of the brake cylinder to the brake cali- per allows the brake to have a short axial installation length. This allows the installation space to be used optimally.
The entire disk brake including brake cylinder consists of one brake caliper and one brake carrier. All of the rubber parts of the brake, including grease fillings, are maintenance free unless damaged. The disk brake is equipped with an electrical wear indicator. G42.10-3314-00 1 Diaphragm cylinder 2 Brake caliper 5 Brake pads 4 Brake disk 3 Holddown springs 6 Pressure plate 54 Introduction of the New Unimog Generation | Model Series 405 – This printout will not be recorded by the update service. Status: 03 / 2013 –