Networking Overall network General CAN information Due to the increase in electronic systems in the new Unimog generation, more and more signals have to be made available throughout the various systems. This mainly affects the net- work, which has further increased in complexity. Alongside the familiar CAN and ASIC data bus systems, the LIN data bus is now being used increasingly. In the new Unimog, there are 3 LIN data buses alone to connect the various control units, switches and other electronic components to each other. On the other hand, the number of CAN data buses has only increased slightly.
CAN data bus system The CAN data bus system makes it possible to exchange information between control units quickly and reliably using few lines. In this case, the information is transmitted and received in succession (serially). Exchange takes place on a bidirectional basis i.e. every control unit acts as both a trans- mitter and a receiver. 64 Introduction of the New Unimog Generation | Model Series 405 – This printout will not be recorded by the update service. Status: 03 / 2013 –