mercedes-benz Unimog Model Series 405 — UGE_Euro6_en.pdf

Tire pressure control system Driving assistance systems The tire pressure control system (code A30) is an electro- pneumatic system installed in the vehicle which is used to inflate and deflate the tires on the front and rear axle. It is also possible to change the tire pressures while driving. The tire pressure control system is operated pneumatically via au- xiliary consumer connection 24 on the four-circuit protection valve. The compressed air supply for tire inflation is provided via a branch upstream of the four-circuit protection valve (high-pressure 18.3 bar) and is limited individually according to the tires. • It is possible to adjust the tire pressure while driving.

• In the event of tire damage, the vehicle can drive to the nearest workshop by means of the pressure loss compen- sation function. • The tire pressure can be adjusted individually at the front and rear axle. • It is possible to equalize the actual rolling circumferences of the front and rear wheels and different axle loads can also be allowed for. • Operation is carried out via the switch on the center con- sole, which allows the tire pressure to be conveniently controlled from the driver's cab. • A tire pressure indicator on the display is used to check settings and recognize pressure loss. • The minimum and maximum tire pressure is limited, which helps to avoid tire damage.

• The tire pressure is monitored electronically and is auto- matically adjusted to the set value. b b Note If necessary, components of the tire pressure control system can be relocated. 75 Introduction of the New Unimog Generation | Model Series 405 – This printout will not be recorded by the update service. Status: 03 / 2013 –