DIAGNOSTIC TROUBLE CODES CODE NUMBER CIRCUIT NAME CONDITION DESCRIPTION 316 321** 322** 324** 325 331* 332* 333* 334 335 346 365* 368* 373 374 375 421-426 431-436 451-456 523 525* 533 534 543* 551 552 553 554 613* 614* 621* 622* 623* 624 626 631 632 655 661 664 665 EWPS EWPS EWPS IST EWPS ICP ICP ICP sys ICP sys ICP sys AMS EGR EGR IAH FPC GPC INJ INJ INJ IDM IDM IDM IDM ECM / IDM ECM / IDM ECM / IDM ECM / IDM ECM / IDM ECM ECM ECM ECM ECM ECM ECM PWR ECM ECM ECM ECM ECM ECM Engine Coolant Temperature unable to reach commanded set point Engine Coolant Temperature above warning level Engine Coolant Temperature above critical level Idle Shutdown Timer enabled engine shutdown Power reduced, matched to cooling system performance Injection Control Pressure above system working range Injection Control Pressure above specification with engine not running Injection Control Pressure above / below desired level ICP unable to achieve setpoint in time (poor performance) ICP unable to build pressure during cranking Faults detected during EGR portion of the AMS test EGR valve position above / below desired level EGR drive module / ECM2 communication fault Inlet Air Heater relay circuit fault Fuel Pump Relay Circuit fault Glow Plug Relay Circuit fault High side to low side open (cylinder number indicated) High side shorted to low side (cylinder number indicated) High side short to ground or VBAT (cylinder number indicated) IDM VIGN voltage low IDM fault IDM relay voltage high IDM relay voltage low ECM / IDM communications fault IDM / CMPO signal inactive IDM incorrect CKPO signal signature IDM CKPO signal inactive IDM incorrect CKPO signal signature ECM / IDM software not compatible EFRC / ECM configuration mismatch Engine using mfg.
default rating Engine using field default rating Invalid Engine Family Rating Code (EFRC) Field default active Unexpected reset fault Read Only Memory (ROM) self test fault Random Access Memory (RAM) - CPU self test fault Programmable parameter list level incompatible RAM programmable parameter list corrupt Calibration level incompatible Programmable parameter memory content corrupt *indicates amber ENGINE lamp on when DTC is set ** indicates red ENGINE lamp on when Engine Warning Protection System is enabled and a DTC is set International ® VT 275 V6 Engine 101