LUBRICATION SYSTEM Diagnostic port EOPS EOT Primary balancer bushing Cam bushing Main bearing Rod bearing Oil filter Filter bypass Lifter Dual turbocharger Piston Cooling tube Oil cooler Cooler bypass To oil pan Oil reservoir for high-pressure pump 0.95 qts To high-pressure oil system Pump regulator 75 psi Oil Pump Right side Left side System Operation • Oil is drawn from the oil pan through the pick-up tube, upper oil pan, lower crankcase and the front cover passage that leads to the oil pump gear set. The oil is moved under pressure by the crank-driven gear set to the outlet port of the pump where pressurized oil is exposed to the pressure regulator valve.
If the pressure is high, the excess oil is returned to the inlet side of the pump. Oil then enters the vertical passage in the crankcase that takes the oil to the oil cooler cover. contains the oil filter bypass valve, which allows oil to bypass the filter if the filter is restricted. After passing through the filter, oil returns to the cooler cover assembly and is directed to the high-pressure pump reservoir and the crankcase passages. Lubrication of the connecting rod bearings is through drilled passages from the main bearing journals to the rod journals.
Each lifter directs oil up the hollow push rod to the rocker arm, where oil from the push rod splash- lubricates the rocker arm and valve stem. The rear gear train is lubricated by splash oil thrown off the rear main bearing and drain oil from the injection pressure regulator. Cooled and filtered oil enters two oil passages at the top of the crankcase. The right passage leads to the right bank oil galley where oil is directed to the crankshaft main bearings, camshaft, right bank lifters, and the right bank piston cooling jets. The left passage leads to the left bank oil gallery where oil is directed to the left bank lifters and cooling jets.
Spray from the cooling jets removes heat from the crown of the pistons. Oil entering the oil cooler cover is directed to the cooler and oil cooler bypass valve. If the oil is cold and thick, the bypass allows oil to enter the filter without moving through the cooler. After passing through the cooler, oil enters the oil adapter assembly and is directed to the filter. The top of the filter standpipe 61 International ® VT 275 V6 Engine