4. Disassembly, Inspection and Reassembly of Engines (4) Piston Especially clean the combustion surface, circumference, ring grooves and piston pin bosses, and check after removing any carbon deposit. Any burr at a ring groove or snap ring groove shall be removed. If crack is suspected, inspect by color check. (a) Piston outside diameter measurement Measure the long diameter at H mm from the bottom end of the piston of the oval hole in the vertical direction to the piston pin hole. Piston outside diameter mm If the clearance between piston and cylinder exceeds the limit, use an oversized piston.
(Refer to the tables of oversized pistons, oversized piston rings and cylinder boring dimension on 4.4.5(1)(c) in chapter 4.) (b) Piston pin hole measurement Measure the outside diameter of piston pin and the inside diameter of piston pin hole. Calculate the clearance between piston pin and piston pin hole. If any data exceeds the limit, replace the part with a new one.
mm 101 Model Outside diameter Standard Limit Clearance between piston and cylinder Measurement position (H) 3TNV82A 81.950 81.980 81.905 0.035 0.065 22 25 3,4TNV84(T) 83.945 83.975 83.900 0.040 0.070 3,4TNV88 87.945 87.975 87.900 4TNV94L 93.945 93.955 93.900 0.050 0.080 22 4TNV98(T) 97.940 97.950 97.895 22 4TNV106(T) 105.930 105.960 105.880 30 Model Item Standard Limit 3TNV82A Pin I.D. 23.000 23.009 23.039 Pin O.D. 22.995 23.000 22.965 Clearance 0.000 0.014 0.074 TNV84 88 Pin I.D. 26.000 26.009 26.039 Pin O.D. 25.995 26.000 25.965 Clearance 0.000 0.014 0.074 4TNV94L 4TNV98(T) Pin I.D. 30.000 30.009 30.039 Pin O.D. 29.989 30.000 29.959 Clearance 0.000 0.020 0.080 4TNV106(T) Pin I.D.
37.000 37.011 37.039 Pin O.D. 36.989 37.000 36.959 Clearance 0.000 0.022 0.080