Troubleshooting Overview C Series Page TS-20 Section TS - Troubleshooting Symptoms Coolant Loss This is symptom tree t019 Cause Correction STEP 1 Coolant level is above specification ............. Check the coolant level. Refer to the OEM service manual. OK Go To Next Step Inspect the engine and its components for seal, gasket, or draincock leaks. Inspect the radiator, heat exchanger, cab heater, hoses, and connections. Pressurize the cooling system if necessary to determine source of leak. Refer to Procedure 008-018. STEP 2 External engine leak ............. OK Go To Next Step STEP 3 Cooling system hose are collapsed, restricted, or .............
Inspect the cooling system hoses for restrictions, obstructions, and leaks. Refer to Procedure 008-045. leaking OK Go To Next Step STEP 4 Cooling system pressure cap is not correct, is malfunctioning, or has a low-pressure rating ............. Inspect the pressure cap. Refer to Procedure 008-047. OK Go To Next Step Check and review OEM plumbing to make sure no high-pressure coolant can cause backflow. Check vent lines and fill line for restriction. Refer to OEM service manual. STEP 5 Coolant loss through radiator overflow ............. OK Go To Next Step STEP 6 Transmission oil cooler or torque converter cooler Check the transmission oil cooler and torque converter cooler for coolant leaks.
Refer to OEM service manual. is leaking ............. OK Go To Next Step STEP 7 Wet exhaust manifold and turbine housing leaking ............. Pressure-test the coolant system. Refer to Procedure 008-018. coolant OK Go To Next Step STEP 8 Coolant is leaking into the lubricating oil ............. Check for coolant in the oil. Refer to the Coolant in the Lubricating Oil symptom tree. OK Go To Next Step