C Series Troubleshooting Overview Section TS - Troubleshooting Symptoms Page TS-25 Coolant Temperature Above Normal - Sudden Overheat This is symptom tree t023 Cause Correction View and troubleshoot the fault codes with INSITE™. Refer to Section TF in the Marine Electronic Control System, C8.3 Engines, Troubleshooting and Repair Manual, Bulletin 4021442. STEP 1 Electronic fault codes active or high counts of ............. inactive fault codes OK Go To Next Step STEP 2 Coolant level is below specification ............. Inspect the engine and cooling system for external coolant leaks. Repair if necessary. Add coolant. Refer to Procedure 008-018.
OK Go To Next Step STEP 3 Belt(s) loose, tight, or not in alignment ............. Check the belt(s). Refer to Procedures 008-002 and 008-080. OK Go To Next Step STEP 4 Temperature gauge malfunction ............. Check or replace the temperature gauge. Refer to the OEM service manual. OK Go To Next Step STEP 5 Sea water cooling system is malfunctioning ............. Troubleshoot the sea water system. Refer to the Coolant Temperature Above Normal - Sea Water Cooling System symptom tree. OK Go To Next Step STEP 6 Airflow to the radiator is restricted (nonmarine ............. Check and repair fan shroud, shutters, shutterstat, sensor, fan clutch, and viscous fan as required.
Refer to the OEM service manual. engines only ) OK Go To Next Step STEP 7 Cooling system hose are collapsed, restricted, or Inspect the cooling system hoses for restrictions, obstructions, and leaks. Refer to Procedure 008-045. leaking ............. OK Go To Next Step STEP 8 Thermostat is not correct or is malfunctioning ............. Check the thermostat for the correct part number and for correct operation. Refer to Procedure 008-013. OK Go To Next Step