Troubleshooting Overview C Series Page TS-48 Section TS - Troubleshooting Symptoms Engine Power Output Low This is symptom tree t057 Cause Correction View and troubleshoot the fault codes with INSITE™. Refer to Section TF in the Marine Electronic Control System, C8.3 Engines, Troubleshooting and Repair Manual, Bulletin 4021442. STEP 1 Electronic fault codes active or high counts of ............. inactive fault codes OK Go To Next Step STEP 2 Excessive load for engine horsepower rating ............. Reduce vehicle load or use low gear if the engine is industrial. If engine is marine, change propeller(s). OK Go To Next Step STEP 3 Fuel shutoff lever (mechanical) partially engaged .............
Check for correct solenoid operation. Refer to Procedure 005-043. OK Go To Next Step STEP 4 Engine will not reach full throttle ............. Make sure the throttle linkage is not misadjusted or damaged. Adjust and repair as necessary. Check the fuel lever for stop-to-stop travel. Refer to Procedure 005-029. OK Go To Next Step Check for accelerator pedal or lever restriction. Check the percent throttle reading on the electronic service tool or Cummins Digital Display. Check the position sensor and the circuit. Verify the accelerator position sensor provides 0- to 100- percent input to the ECM. Adjust as required.
Refer to Section 19 in the Marine Electronic Control System, C8.3 Engines, Troubleshooting and Repair Manual, Bulletin 4021442. STEP 5 Accelerator pedal or lever position sensor or circuit ............. is malfunctioning OK Go To Next Step Verify by operating the engine from a temporary supply of number 2 diesel fuel. Check fuel specifications for proper fuel grade. Refer to Fuel for Cummins Engines, Bulletin 3379001. STEP 6 Poor fuel quality or wrong fuel grade ............. OK Go To Next Step STEP 7 Fuel inlet temperature to pump is above Fill the fuel tank, turn off or bypass the fuel heaters, and check the fuel cooler. Refer to the OEM service manual. specification .............
OK Go To Next Step