C Series Troubleshooting Overview Section TS - Troubleshooting Symptoms Page TS-59 Engine Vibration Excessive This is symptom tree t075 Cause Correction STEP 1 Engine not running smoothly ............. Refer to the Engine Runs Rough or Misfires symptom tree. OK Go To Next Step STEP 2 Fan is loose, damaged, or not balanced ............. Check the fan. Refer to Procedure 008-040. OK Go To Next Step Check the fan hub, alternator, refrigerant compressor, and hydraulic pump for interference. Isolate belt-driven accessories and check for vibration. Refer to OEM service manual. STEP 3 Belt-driven accessories are malfunctioning .............
OK Go To Next Step STEP 4 Vibration damper is damaged ............. Inspect the vibration damper. Refer to Procedure 001-052. OK Go To Next Step STEP 5 Engine mounts are worn, damaged, loose, or not ............. Verify the condition of the mounts. Refer to Procedure 016-010. correct OK Go To Next Step STEP 6 Alternator bearing worn or damaged ............. Clean and replace the alternator. Refer to Procedure 013-001. OK Go To Next Step STEP 7 Power components loose or broken ............. Inspect the crankshaft and rods for damage that causes an unbalance. Refer to Procedure 001-016 or 001-014. OK Go To Next Step Compare the Drivetrain components to the engine and equipment specifications.
Isolate the Drivetrain components, and check for vibrations. Refer to OEM service manual. STEP 8 Drivetrain components are malfunctioning or are ............. not correct OK Go To Next Step STEP 9 Flywheel housing is not aligned correctly ............. Check the flywheel housing alignment. Refer to Procedure 016-006. OK Go To Next Step