C Series Troubleshooting Overview Section TS - Troubleshooting Symptoms Page TS-61 Engine Will Not Crank or Cranks Slowly This is symptom tree t076 Cause Correction STEP 1 Engine speed is low because of cold ambient Use a lubricating oil heater and the correct oil grade. Refer to Operation of Diesel Engines in Cold Climates, Bulletin 3379009. temperature ............. OK Go To Next Step STEP 2 Battery charge is low ............. Check battery. If the battery is low, check the alternator for proper charging. Charge the battery, and replace if necessary. Refer to Procedure 013-001. OK Go To Next Step Check the engine cranking speed with a handheld tachometer or electronic service tool.
If the cranking speed is slower than 150 rpm, refer to the Engine Will Not Crank or Cranks Slowly symptom tree. STEP 3 Engine cranking speed is too slow ............. OK Go To Next Step STEP 4 Poor starter motor ground ............. Check for proper ground between starting motor and battery negative terminal. Repair or replace if necessary. OK Go To Next Step STEP 5 Cranking circuit or battery cable voltage drop Inspect the battery cables for loose or corroded connections, or broken cables. Check the voltage drop in the starting circuit. Repair or replace the battery cables if necessary. Refer to Procedure 013-009. excessive .............
OK Go To Next Step Check the voltage drop in the starting circuit. Refer to Procedure 013-017. Repair or replace starter relay if necessary. STEP 6 Starter relay voltage drop excessive ............. OK Go To Next Step STEP 7 Starter solenoid voltage drop is excessive and ............. Check the starter solenoid voltage and amperage drop. Refer to Procedure 013-019. amperage drain is too high OK Go To Next Step STEP 8 Engine rotation is restricted ............. Rotate the crankshaft using barring tool, Cummins Part number 3824591. OK Go To Next Step