Troubleshooting Overview C Series Page TS-72 Section TS - Troubleshooting Symptoms Intake Manifold Air Temperature Above Specification This is symptom tree t096 Cause Correction View and troubleshoot the fault codes with INSITE™. Refer to Section TF in the Troubleshooting and Repair Manual, Marine Electronic Control System, C8.3 Engines, Bulletin 4021442. STEP 1 Electronic fault codes active or high counts of ............. inactive fault codes OK Go To Next Step STEP 2 Intake manifold temperature sensor is Check the intake manifold temperature sensor. Refer to Procedure 019-061 in the Troubleshooting and Repair Manual, Marine Electronic Control System, C8.3 Engines, Bulletin 4021442.
malfunctioning ............. OK Go To Next Step STEP 3 Charge air cooler fins, radiator fins, or air conditioner condenser fins are damaged or Inspect the charge air cooler, air conditioner condenser, and radiator fins. Clean, if necessary. Refer to Procedures 010-027 and 008-042 and the OEM service manual. ............. obstructed with debris OK Go To Next Step Open the cold weather radiator cover or the winterfront. Maintain a minimum of 784 cm 2 [122 in 2 ] or approximately 28 x 28 cm [11 x 11 in] of opening at all times. Refer to Operation of Diesel Engines in Cold Climates, Bulletin 3379009. STEP 4 Cold weather radiator cover or winterfront is closed .............
OK Go To Next Step STEP 5 Vehicle speed is too low for adequate cooling with high engine load ............. Reduce the engine load. Increase the engine (fan) rpm by downshifting. OK Go To Next Step STEP 6 Fan shroud is damaged or missing or the air recirculation baffles are damaged or missing Inspect the shroud and the recirculation baffles. Repair, replace, or install, if necessary. Refer to Procedure 008-038. ............. OK Go To Next Step STEP 7 Drive belt is loose, tight, or not in alignment ............. Check and adjust the drive belt as needed. Refer to Procedures 008-002 and 008-080.
OK Go To Next Step STEP 8 Radiator shutters are not opening completely, or Inspect the radiator shutters. Repair or replace if necessary. Check the shutterstat setting. Refer to the OEM service manual. the shutterstat setting is wrong ............. OK Go To Next Step