Troubleshooting Overview C Series Page TS-74 Section TS - Troubleshooting Symptoms Intake Manifold Air Heater System Malfunctioning This is symptom tree t097-25 Cause Correction STEP 1 Batteries have failed ............. Check the condition of the batteries, replace if necessary. Refer to Procedure 013-007. OK Go To Next Step STEP 2 Battery cables or connections are loose, broken, or ............. Check the battery cables and connections. Refer to Procedure 013-009. corroded (excessive resistance) OK Go To Next Step STEP 3 Fuse(s) malfunctioning ............. Replace the battery circuit fuse(s). Refer to Procedure 010-122. OK Go To Next Step Check wire gauge, check batteries.
Refer to the Marine Recreational High Output Propulsion Units B and C Series Installation Directions, Bulletin 3884649 and Procedure 010-122. STEP 4 Low voltage ............. OK Go To Next Step STEP 5 Intake manifold heater wiring harness malfunctioning ............. Check the wiring harness. Refer to Procedure 010-122. OK Go To Next Step STEP 6 Solenoid valve is malfunctioning ............. Check for voltage at the solenoid valve. Procedure 010-126 OK Go To Next Step STEP 7 Intake air temperature sensor is malfunctioning ............. Check the intake air temperature sensor. Refer to Procedure 010-123. OK Go To Next Step STEP 8 Intake air heater element malfunctioning .............
Check and replace if necessary. Refer to Procedure 010-124. OK Go To Next Step STEP 9 Engine speed sensor or circuit is malfunctioning ............. Check the engine speed sensor for correct adjustment and for debris on the sensor. Check the engine speed sensor circuit. Refer to Procedure 010-127. OK Go To Next Step