Cummins — 3666003

Troubleshooting Overview C Series Page TS-82 Section TS - Troubleshooting Symptoms Lubricating Oil Sludge in the Crankcase Excessive This is symptom tree t106 Cause Correction STEP 1 Bulk oil supply is contaminated ............. Check the bulk oil supply. Drain the oil and replace with noncontaminated oil. Replace the oil filter(s). Refer to Procedure 007-025. OK Go To Next Step STEP 2 Coolant temperature is below specification ............. Refer to the Coolant Temperature Below Normal symptom tree. OK Go To Next Step STEP 3 Crankcase ventilation system is plugged ............. Check and clean the crankcase breather and vent tube. Refer to Procedure 003-008.

OK Go To Next Step STEP 4 Fuel grade is not correct for the application or the Operate the engine from a tank of high-quality fuel. Refer to Fuel for Cummins Engines, Bulletin 3379001. fuel quality is poor ............. OK Go To Next Step STEP 5 Lubricating oil does not meet specifications for ............. Change the oil and filters. Refer to Cummins Engine Oil Recommendations, Bulletin 3810340 and Procedure 007-025. operating conditions OK Go To Next Step STEP 6 Lubricating oil drain interval is excessive ............. Verify the correct lubricating oil drain interval. Refer to the Operation and Maintenance Manual, C Series Engines, Bulletin 3810248.

OK Go To Next Step STEP 7 Lubricating oil is contaminated with coolant or fuel ............. Change the oil and filters. Refer to the Lubricating Oil Contaminated symptom tree. OK Go To Next Step Check for excessive blowby. Refer to the Crankcase Gases (Blowby) Excessive symptom tree. STEP 8 Crankcase pressure is excessive .............