Troubleshooting Overview C Series Page TS-84 Section TS - Troubleshooting Symptoms Lubricating or Transmission Oil in the Coolant This is symptom tree t108 Cause Correction Check the bulk coolant supply. Drain the coolant and replace with noncontaminated coolant. Replace the coolant filters. Refer to Procedure 007-025. STEP 1 Bulk coolant supply is contaminated ............. OK Go To Next Step STEP 2 Lubricating oil cooler is malfunctioning ............. Check the oil cooler. Refer to Procedure 007-003. OK Go To Next Step STEP 3 Torque converter cooler or hydraulic oil cooler is ............. Remove and inspect the cooler cores and o-rings. Refer to the OEM service manual.
malfunctioning OK Go To Next Step STEP 4 Air compressor cylinder head is cracked or porous, Inspect the air compressor cylinder head and gasket. Refer to the Master Repair Manual, Holset® Air Compressors, Bulletin 3666121. or has a leaking gasket ............. OK Go To Next Step STEP 5 Cylinder head gasket is leaking ............. Check the cylinder head gasket. Refer to Procedure 002-004. OK Go To Next Step Remove intake and exhaust manifolds. Check for evidence of coolant leak. If necessary, operate engine at low idle. Pressure-test the cylinder head. Refer to Procedure 002-004. STEP 6 Cylinder head is cracked or porous .............
OK Go To Next Step STEP 7 Cylinder block is cracked or porous ............. Inspect the cylinder block. Refer to Procedure 001-026.