Cummins — 3666003

Troubleshooting Overview C Series Page TS-88 Section TS - Troubleshooting Symptoms Smoke, White — Excessive This is symptom tree t118 Cause Correction View and troubleshoot the fault codes with INSITE™. Refer to the TF Section in the Troubleshooting and Repair Manual, Marine Electronic Control System, C8.3 Engines, 4021442. STEP 1 Electronic fault codes active or high counts of ............. inactive fault codes OK Go To Next Step Verify the correct starting procedure. Refer to the Operation and Maintenance Manual, Automotive, RV, Bus, and Industrial C8.3 Series (U.

S.), Bulletin 3810248 or the Operation and Maintenance Manual, C Series Recreational, High Output Marine Propulsion Unit, Bulletin 3381968. STEP 2 Starting procedure is not correct ............. OK Go To Next Step STEP 3 Coolant temperature is below specification or the intake manifold air temperature is below ............. Refer to the Coolant Temperature Below Normal symptom tree. specification OK Go To Next Step STEP 4 Intake manifold heater wiring harness Check the wiring harness. Refer to Intake Manifold Air Heater System Malfunctioning troubleshooting tree. ............. malfunctioning OK Go To Next Step Verify by operating the engine from a temporary supply of number 2 diesel fuel.

Check fuel specifications for proper fuel grade. Refer to Fuel for Cummins Engines, Bulletin 3379001. STEP 5 Poor fuel quality or wrong fuel grade ............. OK Go To Next Step Put the engine at top dead center. Check and adjust the fuel timing. Refer to Procedure 005-012 or 005-013. STEP 6 Fuel injection pump timing is not correct ............. OK Go To Next Step STEP 7 KSB is malfunctioning (Bosch VE pump only ) ............. Refer to the OEM service manual. OK Go To Next Step STEP 8 Injector sealing washer not correct ............. Remove injector and install the proper sealing washer. Refer to Procedure 006-026. OK Go To Next Step