C Series Service Tools Section 1 - Cylinder Block - Group 01 Page 1-1 Service Tools The following special tools are recommended to perform procedures in this section. The use of these tools is shown in the appropriate procedure. These tools can be purchased from a local Cummins® Authorized Repair Location. Tool No. Tool Description Tool Illustration 3163264 Engine Lift Fixture Used to lift the engine during the removal and installation procedures. 3377371 Engine Barring Tool Used to engage the flywheel ring gear to rotate the crankshaft. 3823258 Scotch-Brite™ 7448 Abrasive Pad Used to clean carbon from the upper liner bores, remove rust, corrosion, burrs, and scuffing surfaces.
ST-647 Standard Puller Used to remove drive pulleys, impellers, air compressor counterweights, etc. ST-1229 Cylinder Liner Driver Install cylinder liner into cylinder block. 3824500 Wear Sleeve Installer Used to install a wear sleeve to repair crankshafts that have grooves caused by the oil seal.