C Series Camshaft Section 1 - Cylinder Block - Group 01 Page 1-33 Numbers 3924471, 3923388, 3921176, 3923478, 3914640, and 3919799 mm in 59.967 MIN 2.3609 60.013 MAX 2.3627 Camshaft Journal Diameter Wear Limits for Part Camshaft Journal Diameter Wear Limits for Part Numbers 3930347 and 3927693 mm in 53.967 MIN 2.1247 54.013 MAX 2.1265 NOTE: Replace the camshaft if the outside diameter of any journal is below specification. Install Install the tappets. Refer to Procedure 004-015 in Section 4. Apply a coat of clean engine oil to the front camshaft bore. NOTE:
The crankshaft must be positioned so the Number 1 cylinder is at approximately top dead center, so the camshaft does not hit the crankshaft counterweight during installation. Lubricate the camshaft lobes, journals, and thrust washer with clean engine oil.