Connecting Rod C Series Page 1-50 Section 1 - Cylinder Block - Group 01 Replace This tool is used to remove and install the bushings to the correct position. Place the pin bore end of the connecting rod on the mandrel. Place the knock-out (thin ring) on the mandrel on top of the connecting rod. Match up the angle surfaces. Connecting Rod Pin Bore Bushing Removal/ Installation Tool, Part Number 3823690 Reference Number Part Number Description Quantity 1 3823691 Anvil 1 2 3823693 Cup 1 3 3823692 Mandrel 1 4 3823694 Driver ring (thick) 1 5 3823695 Knock-out- ring (thin) 1 6 Hair pin cotter pin 1