Cummins — 3666003

Cylinder Liner C Series Page 1-84 Section 1 - Cylinder Block - Group 01 NOTE: When reusing liners, install them in the same cylinder from where they were removed, and rotate the liner 45 degrees (1/8 of a turn) from their original position. When correctly installed, any liner pitting can be positioned as illustrated so the pitted surface is rotated away from the location where pitting occurs. Install the cylinder liners into the bore of the cylinder block, use cylinder liner driver, Part Number ST-1229, and a leather mallet. NOTE: If the liner does not rest on the cylinder block counterbore seat, remove the liner. Inspect the counterbore seat and liner for nicks, burrs, or dirt.

Install the liner again. Use two cylinder head capscrews and position the two liner clamps, Part Number 3822503, as illustrated. Tighten the capscrews. Torque Value: 68 N•m [ 50 ft-lb ] Remove the clamps and repeat this procedure until all liners have been clamped and released. Liner protrusion is the distance the liner protrudes above the block face. Measure the liner protrusion with the liner protrusion gauge, Part Number 3823495, at four points 90 degrees apart. Cylinder Liner Protrusion mm in 0.025 MIN 0.001 0.122 MAX 0.005