Cummins — 3666003

C Series Gear Housing, Front Section 1 - Cylinder Block - Group 01 Page 1-93 Preparatory Steps Remove the drive belt. Refer to Procedure 008-002 (Drive Belt, Cooling Fan) in Section 8. Remove the vibration damper. Refer to Procedure 001-052 (Vibration Damper, Viscous) in Section 1. Remove the front gear cover. Refer to Procedure 001-031 (Accessory Drive Seal) in Section 1. Remove the accessory drive or air compressor, if equipped. Refer to Procedure 012-014 (Air Compressor) in Section 12. Remove the rocker lever cover. Refer to Procedure 003-011 (Rocker Lever Cover) in Section 3. Remove the rocker lever assemblies. Refer to Procedure 003-008 (Rocker Lever) in Section 3. Remove the push rods.

Refer to Procedure 004-014 (Push Rods or Tubes) in Section 4. Remove the camshaft. Refer to Procedure 001-008 (Engine Mounting Bolts) in Section 1. Remove the tappets. Refer to Procedure 004-015 (Tappet) in Section 4. Remove Support the front of the engine and remove the front engine mount. CAUTION Use extreme care when releasing the oil pan gasket from the gear housing to prevent damage to the gasket. If the gasket is damaged, it will probably be necessary to remove the oil pan and replace the gasket. Loosen all the oil pan mounting capscrews four to five turns. Remove the four front oil pan capscrews that secure the oil pan to the gear housing.

Insert a feeler gauge or a shim stock between the gear housing and the oil pan gasket. Move the feeler gauge or shim stock back and forth to release the gasket from the gear housing.