Cummins — 3666003

Block Stiffener Plate C Series Page 1-138 Section 1 - Cylinder Block - Group 01 Clean and Inspect for Reuse Remove all gasket material from both gasket surfaces. Inspect the block stiffener plate for cracks or other damage. Install Install the block stiffener plate. Use a new gasket and/or RTV sealant as required. NOTE: The engines use a variety of combinations of gaskets and/or RTV sealant. Use the same combination of gaskets and/or RTV sealant as previously removed. NOTE: The block stiffener plate must be held in place while the oil suction tube is installed. Use a few oil pan capscrews or wire ties to accomplish this Finishing Steps Install the oil suction tube.

Refer to Procedure 007-035 in Section 7. Install the oil pan. Refer to Procedure 007-025 in Section 7. Fill the engine with oil. Refer to Procedure 007-037 in Section 7. Operate the engine and check for leaks.