C Series Service Tools Section 2 - Cylinder Head - Group 02 Page 2-1 Service Tools Cylinder Head The following special tools are recommended to perform procedures in this section. The use of these tools is shown in the appropriate procedure. These tools can be purchased from a local Cummins® Authorized Repair Location. Tool No. Tool Description Tool Illustration 3822509 Injector Bore Brush Used to clean carbon from injector bores. 3823921 Capscrew Length Gauge Used to measure capscrew free length. 3375962 Valve Spring Compressor Used to remove and install valve collets.
3823258 Scotch-Brite™ 7448 Used for cleaning carbon from the upper liner bores, removing rust and corrosion from parts, removing burrs from aluminum and other soft metals, and for scuffing surfaces prior to painting. ST-685 Valve Seat Grinding Machine Used to reface the valve seats in the cylinder head. 3375946 Valve Guide Arbor Set Special tapered arbors used with the valve seat grinding machine, Part No. ST-685, to reface the valve seat in the cylinder head.