Cummins — 3666003

C Series Cylinder Head Section 2 - Cylinder Head - Group 02 Page 2-13 1 Recheck the torque on all capscrews. Follow the numbered sequence; check the 14 long capscrews from step 4. Follow the numbered sequence; check the 6 short capscrews (exhaust side) from step 6. Follow the numbered sequence; check the 6 short capscrews (intake side) from step 8. 1 Follow the numbered sequence; from step 2, turn the capscrews 90 degrees as indicated on the capscrew head. Post 1991 - Used Cylinder Block and Used Capscrews NOTE: If using a new cylinder block or new capscrews, do not use this procedure. Reference the new cylinder block or new capscrews in this section.

The top of the cylinder head capscrew is identified with an angle marking. The cylinder head capscrews must be tightened by the five-step “torque plus angle” method, as described here.