Cylinder Head Gasket C Series Page 2-26 Section 2 - Cylinder Head - Group 02 Cylinder Head Gasket (002-021) General Information External head gasket leaks can be detected visually. Liquid soap can be used to locate external leaks. Define a leak as follows: Lubricating oil Coolant Compression. Internal head gasket leaks can be detected by performing a compression check; refer to Procedure 014-012. If the compression is found to be low on adjacent cylinders and the pressure can not be increased by oiling the piston rings, the head gasket is probably leaking between cylinders. Low compression on a single cylinder can be caused by a compression leak into a coolant passage. NOTE:
A compression leak into a coolant passage can result in coolant in the cylinder. A compression leak into the cooling system can normally be detected by a loss of coolant. Coolant will be blown from the cooling system because of the extra pressure in the system. Service Tip: Remove the drive belt from the water pump. Run the engine for 1 to 2 minutes and check for coolant being blown from the cooling system.