C Series Tappet Section 4 - Cam Followers/Tappets - Group 04 Page 4-13 NOTE: The crankshaft must be rotated during the installation process. Only four tappets can be installed at each crankshaft position. Wrap rubber bands around the wooden dowels to secure the tappets. Repeat this process until all tappets have been installed. Install the camshaft. For C Series diesel engines, refer to Procedure 001-008 in Troubleshooting and Repair Manual, C Series Engines, Bulletin 3666003. For C Series gas engines, refer to Procedure 001-008 in Troubleshooting and Repair Manual, C8.3G (Natural Gas) Engines, Bulletin 3666206. Remove the dowel rods and release the tappets in the tappet bores.