Cummins — 3666003

Engine Fuel Heater, Electric C Series Page 5-4 Section 5 - Fuel System - Group 05 Engine Fuel Heater, Electric (005-008) Initial Check NOTE: A bimetallic strip on the filter head acts as a thermostat. The fuel heater will turn on at approximately 1°C [34°F] and turn off at approximately 18°C [65°F]. Remove the 2-pin connector from the fuel heater. Check for the proper voltage at the fuel heater connector. Fuel Heater - Voltage ....12 VDC NOTE: If the voltage is not within specifications, refer to the OEM's troubleshooting and repair manual. Use a multimeter to check the continuity of the fuel heater.

Place the multimeter leads across the pins of the fuel heater; if the heater circuit is open, replace the fuel heater. Remove Disconnect the 2-pin connector from the fuel heater. Disconnect the connector from the water-in-fuel sensor. Push on the fuel drain valve for approximately 5 seconds to reduce fuel spillage during filter removal.