Fuel Injection Pumps, In-Line C Series Page 5-26 Section 5 - Fuel System - Group 05 When using solvents, acids, or alkaline materials for cleaning, follow manufacturer's recommendations for use. Wear goggles and protective clothing to reduce the possibility of personal injury. WARNING Wear appropriate eye and face protection when using compressed air. Flying debris and dirt can cause personal injury. WARNING Make certain that the o-ring seals for the fill orifice and pilot are correctly installed and are not damaged. Lubricate the mounting flange with clean lubricating engine oil.
Before installing the fuel pump drive gear, clean the injection pump shaft and gear tapers with QD Contact Cleaner, Part Number 3824510, by spraying into the gap between the shaft and gear. Dry the surface with compressed air. Slide the fuel injection pump shaft through the drive gear, and position the fuel injection pump flange onto the mounting studs. CAUTION Do not pull the injection pump into the gear housing with the mounting nuts. Damage to the gear housing and fuel pump can result. Install the fuel injection pump mounting nuts. Install the support bracket, if equipped. Torque Value: Mounting nuts Step 1 44 N•m [ 32 ft-lb ] Torque Value: Support bracket nuts Step 1 32 N•m [ 24 ft-lb ]