Cummins — 3666003

Fuel Pump Idle Speed C Series Page 5-36 Section 5 - Fuel System - Group 05 Fuel Pump Idle Speed (005-029) Adjust RSV Governor Solenoid Idle speed adjustment for engines with RSV governors requires the setting of both the low-idle speed screw (1) and the bumper spring screw (2). Loosen the locknut and back out the bumper spring screw until there is no change in engine speed. Loosen the locknut and adjust the idle speed screw to 40 to 50 rpm less than the desired speed. Turn the idle speed screw: Counterclockwise to decrease rpm Clockwise to increase rpm. Tighten the locknut. Torque Value: 8 N•m [ 72 in-lb ] Turn the bumper spring screw clockwise until the desired idle speed is obtained.

Tighten the locknut. Torque Value: 8 N•m [ 72 in-lb ]