C Series Fuel Inlet Restriction Section 6 - Injectors and Fuel Lines - Group 06 Page 6-9 Install the fuel filter on the filter head. Turn the filter until the gasket contacts the filter head surface. CAUTION Mechanical overtightening of the fuel filter can distort the threads and damage the fuel filter. Tighten the fuel filter an additional 1/2 to 3/4 of a turn after the gasket contacts the fuel filter head surface, or as specified by the fuel filter manufacturer. Fuel Inlet Restriction (006-020) Initial Check Install a fitting at the inlet of the transfer pump. Install a vacuum gauge, Part No. 3375274. Vacuum Gauge Range mm Hg in Hg 0 to 508 MIN 0 to 20 Start the engine.
Run at low or high idle. Inlet Restriction at Low/High Idle mm Hg in Hg 101.6 MAX 4.70