Cummins — 3666003

Injector C Series Page 6-14 Section 6 - Injectors and Fuel Lines - Group 06 Injector (006-026) General Information All engines use 7-mm closed nozzles, hole-type injectors. However, the injectors can have different part numbers for different engine ratings. The last four digits of the Cummins part number is used to identify the injectors. Use only the specified injector for the engine. During the injection cycle, fuel under high pressure from the fuel injection pump rises to the operating (pop-off) pressure that causes the needle valve in the injector to lift. Fuel is then injected into the cylinder.

A shimmed spring is used to force the needle valve closed as the injection pressure drops below the pop-off pressure. The shimmed spring seals off the nozzle after injection. 1. High-Pressure Fuel Line 2. Fuel Drain Manifold. Failure of the needle valve to lift and close at the correct time, or the needle valve sticks open, can cause the engine to misfire and produce low power. Fuel leaking from the open nozzle can cause: 1. Fuel knock 2. Poor performance 3. Smoke 4. Poor fuel economy 5. Rough-running engine. Initial Check To find which cylinder is misfiring, operate the engine and loosen the fuel line nut at one injector, and listen for a change in engine speed.

A drop in engine speed indicates the injector was delivering fuel to the cylinder. Inspect each cylinder until the malfunctioning injector is found. Make sure to tighten the fuel line nut before proceeding to the next injector.