Cummins — 3666003

C Series Lubricating Oil Filter (Spin-On) Section 7 - Lubricating Oil System - Group 07 Page 7-9 Operate the engine at each rpm indicated and record the corresponding pressure values: A pressure drop greater than 172 kPa [25 psi], at operating temperature using 15W-40 oil, indicates the filter is plugged. Identify the causes of a plugged filter. Verify the Cummins Inc. maintenance guidelines are being met. Use the following procedure to check for possible fluid contamination. Refer to Procedure 007-083 in Section 7. Change both the lubricating oil and the lubricating oil filter, if the filter is plugged.

See the following bulletin for additional information about lubricating oil filter plugging. Refer to Cummins® Engine Oil and Oil Analysis Recommendations, Bulletin 3810340. Remove Clean the area around the lubricating oil filter head. Remove the oil filter with oil filter wrench, Part No. 3375049. Clean the gasket surface of the filter head. Install Lubricate the oil filter gasket with clean engine oil. Fill the oil filter with clean engine oil. Install the filter on the oil filter head. Tighten the filter until the gasket contacts the filter head surface. Use oil filter wrench, Part No.

3375049, to tighten the filter an additional Ѕ to ѕ of a turn, or follow the instructions supplied with the oil filter. Engine RPM Oil Pressure Filter Inlet Oil Filter Pressure Outlet Inlet - Outlet = Differential Pressure INSITE™ electronic service tool Low Idle High Idle