C Series Radiator Pressure Cap Section 8 - Cooling System - Group 08 Page 8-43 If a liquid refrigerant system (air conditioning) is used, wear eye and face protection, and wrap a cloth around the fittings before removing. Liquid refrigerant can cause serious eye and skin injuries. WARNING To protect the environment, liquid refrigerant systems must be properly emptied and filled using equipment that prevents the release of refrigerant gas into the atmosphere. Federal law requires capturing and recycling the refrigerant. WARNING Use care in removing the refrigerant system, if equipped, before removing the radiator.
Radiator Hoses (008-045) Maintenance Check Check all hoses for cracks, cuts, or collapsing. NOTE: The silicone engine coolant hose will exhibit swelling due to the elasticity of the hose. If damage is found, replace damaged hoses. Contact your local Cummins Authorized Repair Location. Radiator Pressure Cap (008-047) Inspect for Reuse Be sure the correct radiator cap is being used. Refer to Procedure 018-018 in the Troubleshooting and Repair Manual, C8.3G, C Gas Plus and L Gas Plus Engines, Bulletin 3666206 or Procedure 018-018 in the Troubleshooting and Repair Manual, C Series Engines, Bulletin 3666003. Inspect the rubber seal of the pressure cap for damage.
Inspect the radiator fill neck for cracks or other damage. Refer to the equipment manufacturer's service manual for instructions if the fill neck is damaged. Pressure-test the radiator cap. The pressure cap must seal within 14 kPa [2 psi] of the value stated on the cap, or it must be replaced. Refer to the equipment manufacturer's service manual for radiator cap test procedure.