C Series Engine Testing (Chassis Dynamometer) Section 14 - Engine Testing - Group 14 Page 14-5 Test Check the coolant level only when the engine is stopped. Wait until the coolant temperature is below 50°C [120°F] before removing the pressure cap. Failure to do so can cause personal injury from heated coolant spray. WARNING The following procedure assumes that the lubricating oil and fuel systems were correctly primed, the dipstick calibrated, and the engine filled to the correct levels with lubricating oil and coolant during installation of the engine into the chassis. If these systems were not serviced during installation of the engine.
Use the following procedures for instructions on priming the lubricating oil and the fuel system and calibrating the dipstick. Use the following procedure in the Service Manual, ISF2.8 CM2220 F101. Refer to Procedure 014-006 in Section 14. Use the following procedure in the Service Manual, ISF2.8 CM2220 E and ISF2.8 CM2220 AN Bulletin 4022178. Refer to Procedure 014-006 in Section 14. Use the following procedure in the Service Manual, ISF2.8 CM2220 E and ISF2.8 CM2220 AN Bulletin 4022178. Refer to Procedure 014-006 in Section 14. Use the following procedure in the Service Manual, ISF3.8 CM2220 Bulletin 4021704. Refer to Procedure 014-006 in Section 14.
Use the following procedure in the Troubleshooting and Repair Manual, ISB and QSB5.9 Engines, Bulletin 3666193. Refer to Procedure 014-006 in Section 14. Use the following procedure in the Troubleshooting and Repair Manual, B3.9, B4.5, and B5.9 Series Engines, Bulletin 3666087. Refer to Procedure 014-006 in Section 14. Use the following procedure in the Troubleshooting and Repair Manual, ISC, ISCe, QSC8.3, ISL and QSL9 Engines, Bulletin 4021418. Refer to Procedure 014-006 in Section 14. Use the following procedure in the Troubleshooting and Repair Manual, C Series, Bulletin 3666003. Refer to Procedure 014-006 in Section 14.
Use the following procedure in the Troubleshooting and Repair Manual, ISB, ISBe 4 and 6 Cylinder, Bulletin 4021271. Refer to Procedure 014-006 in Section 14. Use the following procedure in the Troubleshooting and Repair Manual, B Series, Bulletin 3810207. Refer to Procedure 014-006 in Section 14. Use the following procedure in the QSL9 CM2350 L102 Service Manual, Bulletin 4332796. Refer to Procedure 014-006 in Section 14. Reference the Operation and Maintenance Manual for instructions on filling the lubricating oil and the cooling systems.