C Series Service Tools Section 16 - Mounting Adaptations - Group 16 Page 16-1 Service Tools Mounting Adaptations The following special tools are recommended to perform procedures in this section. The use of these tools is shown in the appropriate procedure. These tools can be purchased from a local Cummins® Authorized Repair Location. Tool No. Tool Description Tool Illustration 3375066 Pipe Sealant Used on capscrew threads and pipe plugs. 3823709 Idler Shaft Puller and Capscrew Used to remove idler shaft from idler gear and flywheel housing. 3823891 Gear Locking Tool Used to prevent rotation of the power take-off output shaft while tightening the output flange capscrew.
3823892 Offset Wrench (C Series Engine) Used to tighten the hidden capscrews in the REPTO flywheel housing. 3823893 Bearing Race Driver Used to install output shaft bearing races. ST-1325 Dial Indicator Attachment Used to attach to crankshaft flange to provide measuring of flywheel and flywheel housing runout with dial bore gauge.