Cummins — 3666003

C Series Flywheel Section 16 - Mounting Adaptations - Group 16 Page 16-5 Inspect the flywheel ring gear teeth for cracks and chips. NOTE: If the ring gear teeth are cracked or broken, the ring gear must be replaced. Refer to Procedure 016-008. Measure Flywheel Bore Runout Use the dial indicator gauge (1), Part Number 3376050, or its equivalent, and dial gauge attachment (2), Part Number ST-1325, to inspect the flywheel bore (3) and the surface (4) runout. Install the attachment to the flywheel housing. Install the gauge on the attachment. Install the contact tip of the indicator against the inside diameter of the flywheel bore, and set the dial indicator at zero.

Use the barring tool, Part Number 3824591, to rotate the crankshaft one complete revolution. NOTE: The total indicator reading (TIR) must not exceed 0.127 mm [0.0050 in]. WARNING The component weighs 23 kg [51 lb] or more. To reduce the possibility of personal injury, use a hoist or get assistance to lift the component. NOTE: If the total indicator reading (TIR) is greater than the specification, do the following: Remove the flywheel.