Cummins — 3666003

Engine Testing - Overview C Series Page F-42 Section F - Familiarization The engine can be fitted with a cylinder block heater, oil pan heater, and/or an intake manifold heater. The accompanying illustrations show typical parallel and series battery connections: Parallel connection Series connection. Engine Testing - Overview (014-999) General Information The engine test is a combination of an engine run-in and a performance check. The engine run-in procedure provides an operating period that allows the engine parts to achieve a final finish and fit. The performance check provides an opportunity to perform final adjustments needed to optimize the engine performance.

An engine test can be performed by using a chassis dynamometer. If a dynamometer is not available, an engine test must be performed in a manner that simulates a dynamometer test. Check the dynamometer before beginning the test. The dynamometer must have the capability to test the performance of the engine when the engine is operating at the maximum rpm and horsepower range (full power). The engine crankcase pressure, often referred to as engine blowby, is an important factor that indicates when the piston rings have achieved the correct finish and fit. Rapid changes of blowby or values that exceed specification more than 50 percent indicate that something is wrong.

The engine test must be discontinued until the cause has been determined and corrected.