MAY 2003 29. Disconnect the following connectors from where the electric parts cover was removed: Main harness ground 1, 2 and main harness ground 3, 4. Fuse box 4P connector. PGM-FI main relay 2P connector. PGM-FI main relay 6P connector. Service check 4P connector. Indicator code 3P connector. Switch panel 14P connector. Neutral switch 2P connector. Ambient pressure sensor 3P connector. Fuse box 3P connector. FUSE BOX 4P CONNECTOR PGM-FI MAIN RELAY 2P CONNECTOR PGM-FI MAIN RELAY 4P CONNECTOR FUSE BOX SERVICE CHECK 4P CONNECTOR INDICATOR CODE 3P CONNECTOR SWITCH PANEL CABLE 3P CONNECTOR 30. Before removing the main engine harness: HARNESS BAND CLIP Release connectors from brackets.
Release harness band clips that secure different harness parts to engine covers, brackets, etc. PINCH Open cable clips to release parts of the main engine harness. CABLE CLIP Page 14 of 2 0 AMBIENT PRESSURE 3P CONNECTOR MAIN HARNESS CTOR GROUND 1 AND 2 CK OR E ABLE MAIN HARNESS GROUND 3 AND NEUTRAL SWITCH AMBIENT PRESSURE 3P CONNECTOR MAIN HARNESS GROUND 1 AND 2 MAIN HARNESS GROUND 3 AND TRAL SWITCH NEU CONN BRACKE ECTOR T