MAY 2003 13. If throttle arm does not contact the full throttle stop, loosen the cable pivot lock nut. 14. Remove the cable pivot from the throttle arm pin. Turn the cable pivot as necessary until the throttle arm contacts the full throttle stop when the remote control lever is in the full throttle position. 15. Grease the throttle arm pin then reconnect the cable pivot to the throttle arm pin. 16. Tighten the cable pivot lock nut. 17. With the remote control lever in the full throttle position, check to see if there is a 1 mm (0.04 in) gap or less between the throttle lever and the full throttle stop. 1 mm (0.04 in) OR LESS STOP 18.
If adjustment is required, loosen the OPEN and CLOSE side lower lock nuts. ADJUSTING NUTS 19. Move the OPEN and CLOSE side adjuster nuts up or down until a 1.0 mm (0.04 in) gap or less is obtained between the throttle lever and the full throttle stop with the remote control lever in the full throttle position. OPEN SIDE CLOSE SIDE 20. Tighten the OPEN and CLOSE side lower lock nuts. LOCK NUTS Page 17 of 2 0 T A CABLE PIVOT HROTTLE RM PIN UT LOCK NUT CABLE PIVOT UT LOCK NUT ABLE PIVOT UT 4 in) HROT THROTTLE LEVER TLE