honda — 2000 -1996

4 (2) Installation of the water separator To use the new VSP, add the water separator shown in the picture below to the location shown in the picture on the left. Step 1. Attach the water separator via the stay. When doing this, fasten the lower stay mounting bolt (switching from the current “M6×12” to the new “M6×14”) and the neutral switch stay together. When the upper one is fastened, the silencer is fastened, too Step 2. Detach the tube “A” shown in the above picture on the left and install the water separator tube (“B” in the above picture) as shown in the picture below. Step 2a. Drain tube clip insertion hole. Step 2b Fix the neutral switch harness and tube ‘B” using clips.