HONDA MPE MOTORCYCLE & POWER EQUIPMENT ACN.006 662 862 Service Bulletin BULLETIN NO : SBPE200241 BULLETIN TO : MARINE DEALERS ATTENTION : Marine Service Department FROM : Service Department DATE : August 2002 SUBJECT : BF 175/200/225 (water in vapor separator) Ladies and Gentlemen, Under some conditions a negative pressure can form in the vapor separator, which may cause water to be sucked through the air vent into the vapor separator. This will make the engine hard to start. (This modification should be carried out when the unit comes in for service!) Symptom Poor engine performance or the engine will not start. Cause When the fuel cools in the vapor separator a negative pressure can form.
If the vapor separator tube is under water, the water may be drawn into the vapor separator and mix with the fuel. Countermeasure A hole with a diameter of 1.0 mm is added to the side face of the fuel tube joint which is in the middle of the air vent. Applicable frame number on production line Model Serial Prefix Serial Number BF 200 A BAEJ 1000001-1000808 BAFJ 1100001-1100127 BF 225 A BAGJ 1000001-1002792 BAHJ 1100001-1100084