Installation Step 1 : Remove propeller shaft holder as per work shop manual. Step 2 : Remove the bearing holder using special tool 07WAA-S1G0100. Step 3 : Install the thrust bearing shim as per the diagram below fig -4. Step 4 : Reinstall the bearing holder and tighten the torque to 191 Nm (19.5 kgm). Then make sure the propeller shaft turns freely in neutral position . BRUCE BUTT National Service Manager PLEASE ENSURE ALL RELEVANT STAFF ARE AWARE OF THIS BULLETIN AND ITS CONTENTS. ........................ ........................ .............................. .......................... SERVICE MANAGER PARTS MANAGER SALES MANAGER DEALER PRINCIPAL