HONDA MPE MOTORCYCLE & POWER EQUIPMENT ACN.006 662 862 Service Bulletin BULLETIN NO : SBMA200217 BULLETIN TO : WA,NT and QLD MARINE DEALERS ATTENTION : SERVICE MANAGER AND RELEVANT STAFF FROM : Service Department DATE : March 2002 SUBJECT : BF 20 to 130 Mount frame Gaskets Ladies and Gentlemen, It has come to our attention that in some rare cases the engine may overheat while being driven at a constant speed. This may be due to sediment building up inside the engine blocking the coolant passages in the mount case leading to overheating. This is more likely to occur in areas with high calcium content in the water.
This bulletin only apples to QLD, NT and WA The models that could be affected are the BF 20 through to the BF130. If you think you have an engine suffering from these symptoms, you must contact the service department for pre approval. Symptom: The engine may overheat under normal operating conditions while being driven at a constant speed. The engine tell tail may also constantly block. Cause: The diameter of the coolant supply passage in the mount frame gasket is not adequate to pass large particles through it.