SAFETY SUPPORT MAINTENANCE PROPERLY Explosive separation of a tire and rim parts can cause seri- ous injury or death. • Do not attempt to mount a tire unless you have the prop- er equipment and experience to perform the job. Have it done by your authorized dealer or a qualified repair ser- vice. • Always maintain the correct tire pressure. DO NOT inflate tire above the recommended pressure. • When inflating tires, use a chip-on chuck and extension hose long enough to allow you to stand to one side and not in front of or over the tire assembly. Use a safety cage it available. • Inspect tires and wheels daily.
Do not operate with low pressure, cuts bubbles, damaged rims, or missing lug bolts and nuts. • Never cut or weld on an inflated tire or rim assembly. Heat from welding could cause an increase in pressure and may result in tire explosion. SA-249 521-E02A-0249 PREVENT PARTS FROM FLYING Travel reduction gears are under pressure. • As pieces may fly off, be sure to keep body and face away from AIR RELEASE PLUG to avoid injury. • GEAR OIL is hot. Wait for GEAR OIL to cool, then gradually loosen AIR RELEASE PLUG to release pressure. 503-E03A-0344 SA-344 S-23