Check Chassis Range! 0000 - Overall system/tractor A - General Important notes on work safety The statutory accident prevention regulations (available from professional associations or specialist shops) must be ob- served. These depend on the operating site, operating mode and fuels and lubricants used. Special protective measures dependent on the respective procedures are specified in the corresponding repair guidelines and highlighted. Please observe the following when carrying out maintenance or service work to the tractor: Only the documentation associated with the vehicle (workshop manual and operator's manual) must be used to complete any pending work.
Pressure accumulator and connected lines are highly pressurised. Only remove and repair in accordance with instruc- tions set out in the workshop manual. Before working on the electrical system, always remove the earth strap from the battery. Observe the following when carrying out electric welding. Before carrying out welding work on tractor or mounted implements, ensure that both battery terminals are disconnected. Attach the earth terminal of the welding appliance as close to the welding spot as possible. 13 T003309 Version 1 20-10-2009 This handbook uses the following safety tips D ANGER :
Indicates an impending dangerous situation that will lead to serious injury or death if not avoided. W ARNING : Indicates a potentially dangerous situation that could lead to serious injury or death if not avoided. C AUTION : Indicates a potentially dangerous situation that could lead to minor injury if not avoided. Pressurised fluids (fuel or hydraulic oil) escaping under high pressure can penetrate the skin and cause severe inju- ries. If this should occur, seek medical advice immediately to avoid the risk of serious infection. Run the tractor for a short time, then retighten all wheel nuts and bolts and check them regularly. For correct torque values refer to TECHNICAL DATA.
Caution is required when dealing with brake fluid and battery acid as these are toxic and corrosive! Nobody may be in the cab while work is being carried out under the jacked-up tractor. To avoid eye injury, do not look directly at the surface of the activated radar sensor. Only briefed personnel may operate the tractor or carry out maintenance work. Never open or remove any safety devices while the engine is running. Only use qualified specialists to carry out repairs or service work. Specialist knowledge and special fitting tools are required to fit tyres. Keep clear of any suspended, unsecured load (lifted cab etc.). Relieve pressure from implement lines, e.g. front loader.
4 Safety briefing and measures Keep at a safe distance from hot areas. Dispose of oil, fuel and filters properly. Only use genuine FENDT spare parts. 2. Working on the front axle suspension 1. General