Fendt 900 Vario COM III — 1 General information on calibration

0000 - Overall system/tractor F - Setting and calibrating I000761 Fig. 1. 229 T000330 Version 2 12-07-2007 To compensate for mechanical and electrical tolerances in sensors, the sensors concerned must be calibrated. If a sensor is replaced, it must be calibrated. The following sensors and functions require calibration 1. Rear EPC calibration (depth control code 8001 and rear power lift position code 8002) 9. Steering calibration (steering angle sensor code 2401/Autoguide control valve code 2403) Calibrations 12 to 18 must be performed in sequence and en block (transmission calibration). The transmission emergency operation must not be switched on during calibration.

(Transmission oil temperature higher than approx. 40°C during transmission calibration). If incorrect values are detected or the conditions are not met, an ERROR message appears If calibration completes successfully, OK is displayed, and the new sensor settings are stored. Data are only accepted when ignition key is turned to position "0". (Wait for at least 15 seconds before switching on the ignition again!) 4. Calibration, linear module 1 (hydr. auxiliary control valve) (code 1003) 5. Calibration, linear module 2 (hydr. auxiliary control valve) (code 1004) 6. Calibration, linear module 3 (hydr. auxiliary control valve) (code 1005) 7.

Calibration, linear module 4 (hydr.auxiliary control valve) (code 1006) 3. Calibration, crossgate lever (hydr. auxiliary valves) (code 1001) 1 General information on calibration 16. Calibration, transmission ratio characteristic (code 4007) Calibrations 1 to 11 and 19 can be performed in any order. Press one of the buttons repeatedly until the symbol (A) flashes 919 .. 0101-1000 925 .. 1001- 934 .. 0101-1000 919 .. 1001- 928 .. 0101-1000 934 .. 1001- 922 .. 0101-1000 928 .. 1001- 922 .. 1001- 931 .. 0101-1000 925 .. 0101-1000 931 .. 1001- 2. Calibration, EPC front (code 9001 and code 9002) 8. Calibration, front axle suspension (code 7666) 10.

Calibration, rear PTO coupling time (code 6034) 11. Calibration, front PTO coupling time (code 7034) 17. Calibration, turbo-clutch function (code 4009) 18. Calibration, throttle pedal resolution (code 4010) Press "Return", the first main menu appears in the multiple display Press "Return", the second main menu appears in the multiple display 12. Calibration, drive clutch pedal (code 4001) 14. Calibration, travel range selector (code 4003) 15. Calibration, foot throttle pedal (code 4005) Menu levels on the A007 instrument panel 13. Calibration, hand throttle (code 4002) N OTE : Observe the calibration sequence. 19. Calibration, heater valve (no code) If no error message is present:

F - Setting and calibrating