Turbo-clutch pressure-limiting valve 4V4/Y004 If the max. pressure is not reached during a high pressure measurement, the cause may originate from the drive train or may lie outside in the valve block. To decide if it is necessary to dismantle the drive train, one should first check the valve block (transmission control system) for leaks. The turbo-clutch valve (4V4) controls the PH high-pressure in proportion to the engine speed up to 1250 rpm. This achieves the turbo-clutch function. The turbo-clutch valve is fitted to the valve block, which also comprises the connection from the PH high-pressure circuit to the tank. If this connection is not closed, i.e.
the turbo-clutch valve is not completely closed, high pressure build-up is not possible and the tractor does not achieve the maximum traction performance. The turbo-clutch valve (4V4) closes the PH high-pressure circuit to the tank. I002091 Fig. 7. The turbo-clutch valve is controlled from the electronics box. The electrical current drawer depends on the engine speed and is as follows: 800 rpm 0 A 0 bar Transmission neutral 800 rpm 0.34 A 78 bar Transmission active Engine speed Current draw max. PH Note 5 Inspecting the clutch or turbo-clutch pressure-limiting valve In order to carry out a leakage check it is possible to lock the turbo-clutch valve mechanically. 919 .. 0101-1000 925 ..
1001- 934 .. 0101-1000 919 .. 1001- 928 .. 0101-1000 934 .. 1001- 922 .. 0101-1000 928 .. 1001- 922 .. 1001- 931 .. 0101-1000 925 .. 0101-1000 931 .. 1001- 1200 rpm 1.02 A 105 bar from 1250 rpm 1.40 A 540 bar 1005 - Overall system/transmission E - Measuring and testing 32 T000736 Version 1 07-11-2007 E - Measuring and testing Engine speed Current draw max. PH Note 800 rpm 0 A 0 bar Transmission neutral 800 rpm 0.34 A 78 bar Transmission active 1200 rpm 1.02 A 105 bar from 1250 rpm 1.40 A 540 bar